![]() ![]() If booting the NAS without hard drive still doesn't work, you will need to contact the reseller that you bought from for RMA. However, if you have important data, and you do not want to re-initialize, you need to contact tech support to help you to recover. They get assigned IP-adresses and show up as connected wired devices. After I switched from my D-Link DIR-655 router to the Orbi AC3000 I cannot access the NAS machines. However I cannot find the device on the network using the QFinder app or the Cloud App. The light on the from of the unit flashes orange which apparently indicates it has a network connection according to the manual. If you can connect to the NAS after booting it without hard drive, you can hot plug your hard drives in and re-initialize. I have a couple of Qnap NAS servers that Ive used for several years (TS-419 and TS-419P). They are brand new and I have just plugged them in. However, if your firmware version is too old and 10-second reset is not available for your version, or for any reason that 10-second reset does not work for you, you can try booting the NAS without hard drive. However, the share folder information will be wiped out so you will need to recreate your share folders with the "enter path manually" option to re-establish connection to share folders. Follow the instructions to change the admin password. If your NAS is a legacy model: Use the command configutil 1. Re: QTS stuck on loading, QFinder cannot find Nas either. If you ever replace a member drive with a new drive, the new drive must be synchronised with the array. Its a more involved operation than scrubbing, so it takes longer to perform. Input reboot then press Enter to reboot the NAS. Follow the steps for Basic System Reset (2 (secs) as documented in the Hardware section of the fine manual.Doing so will reset the 'admin' credentials to 'admin'/'admin', and will reset the network settings to DHCP. Which will be needed if a drive fails and the array needs to recover. The 10-second reset will not delete your data. Follow the instructions to change the admin password. Solution In QNAP NAS Make sure the NAS is running the last firmware. Pre-requirement on the NAS is the bcclient process dealing with this kind of traffic. Some routers might block broadcast traffic between LAN and WLAN, with unluckily configured switches sometimes even on the LAN. After your NAS is rebooted, QNAP finder should be able to find it. As long as the NAS is in the same broadcast domain, Qfinder should be able to discover the NAS. This is an indication that your configurations have been reset. In around 10 seconds, you will hear a second beep. Press and hold for around 3 seconds, you will hear a beep, do not let go. I have setup vlans across two of the NICs lan2 and 3 and for devices' needing access to ever or rules have been put in place. ![]() First thing you should try is the reset button on the back of the unit. Kalmiany Dec 10, 2020, 5:12 AM Hi I have pfsense setup on a computer which has a wan lan1, is a secure network, lan2 is where most of computers and IoT things live inducing the nas and lan3 which has a tp-link ap attached. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |